Tractor Talk Discussion Board |
Correct dyno operation
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JS on June 30, 2001 at 20:16:07 from (152.163.197.53):
I have been fortunate enough to have access to a dyno to check my tractors. Directions I were given: 1. Set factory RPM on tractor. 2. Hook up dyno (warm oil to operating temp. 3. Engage pto and apply drag until pto rpm to 540. 4. Read gauge for HP. I followed these directions on an Allis wd45 diesel, turned 52.5 hp @ 540 pto rpm and immediately dropped when appyling more drag. I then put an Oliver 88 diesel on it, turned 35 hp @ 540 pto rpm and climbed to 57 when I applied more drag. Is this correct operation, and on the oliver how many hp does it have, 35 @ 540 or 57 when drag aggressively applied? My goal is to become a little more competitive at the pulls. Thanks for any input on this subject.
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|