Posted by Allan In NE on June 09, 2010 at 08:49:59 from (148.66.88.254):
In Reply to: Allan in NE posted by dhamps10 on June 09, 2010 at 06:05:47:
Hi Neighbor,
Good question! People are always asking me where I get my backing tracks. I don’t have any backing tracks. :>)
I use a somewhat dated technology called "midi". Stands for "musical instrument device interface".
I.E. A musical instrument can be made to communicate with any other "midi" instrument and this technology can be used to generate wanted tones on the fly.
Since music is nothing more than certain tones/instruments/volumes happening at exact times, these tones can be "programmed", manipulated and made to happen at the exact times wanted within any given song.
Downside is that it takes a lot of expensive equipment and even more labor/time/hair-pulling to make it happen exactly like I want it to. One song will usually take me anywhere from 3 weeks to sometimes months to program.
Here's a screen shot of the bass programming for just 6 measures of an intro. This "sequence of events" is then fed from the electronic clock of my laptop into a tone generator; the flat gizmo in the second picture. This little guy will then generate the bass and the drum sounds for me.
I know, I know. I've never been able to explain it very well. :<(
All I can tell ya is that it took me 10 years to figure it all out and make it work as it should with the end result being that I and I alone can play the whole darned she-bang and do it with absolutely nothing being pre-recorded.
It all happens instantaneous and live and at that point all I have to do is play that goofy guitar over the top of it all. :>)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
