Normally I lurk but this time I feel the urge. Rigth now I'm building a house--not real big just a one story 2500 sq. ft. home with basement. The concrete guy almost begged for the job; had had no work since October (we poured in April) and was down to his last four or five workers. He needed the cash. The concrete supplier thought he would charge over a $100/yd; he decided that something was better then nothing when I just stated "OK I'm going to your competitor for under 90/yard. My framer is about 20% under all the other bids--they called him last week asking for work. Brick mason the same thing. I'm with Gun Guru if you can turn down work then you must be doing fine. Don't start your equipment, get fat and lazy the guy that out there hussling and working for less still has $ coming in and more importantly his reputation is growing. My framer has two builders standing in line asking for bids--he's growing his buisness.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.