Posted by Lanse on June 03, 2010 at 18:19:34 from (65.89.42.149):
Hey guys...
On your advice, i decided to keep a watch out for a used, cheap, big compressor instead of making one from a water heater.
So, i picked up a 60 gallon husky air compressor off craigslist for $250.
I got it home, and looked it over. I started it up, and noticed the pressure switch assembly leaked like crazy. So, i picked up a new one, along with the regulator cuz mine was missing.
I took it back to the shop, and everything looked fine, except this little rubber line.
The line starts at the copper tube between the pump and the tank
And ends in the pressure switch.
It diddnt fit the new one, so, thinking it was probally something low pressure, i taped it to the new pressure switch (duct tape fixes everything, right??) with lots of tape, and fired it up. It went pop and started flying all over the place. looking back, that was a really stupid idea....
But oh well...
So, not thinking it was too important, i grabbed a rag and some vice grips and clamped it shut. Then i started the compressor back up.
A few minuites later
BOOM
And a cloud of smoke. Sparks started flying everywhere as the tank began to decompress...
I ran around the compressor and pulled the plug, then back around to the other side to pull the lever on the valve on the tank.
I realised what had happened as about 90 psi drained out of the 60 gallon tank, and then smoke started leaving the garage.
I got it all on video. Ive sat here and watched it a dozen times. Id post it, but its got some choice language in it.
Anyways, i learned something today. Take that as a lesson from me, and never, never ever clamp lines on a compressor closed.
But what the heck is that line?? What does it do?? Where can i find a replacement??
Any ideas?? Thanks guys...
And one more thing...
I put an add on craigslist looking for a used pressure regulator. I diddnt find one, but someonebody offered me a used compressor that the pump went bad on.
He diddnt say how big, but is there any way i could buy it, and plumb it to my compressor, like as a reserve tank??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
