Go for the 9. I have had seveal 7's, and several 9's. Pull type and three point. The pull type can get pretty trick backing up. The reasons you want a 9 are: You can mow from the road down a steep bank further, then get in the ditch and reach up to where you cut from the road. You can stay away from those sidehill adventures. You might also find some other hay mowing to do and the 9 will seem pretty SHORT! I have a huge yard that I was spending a lot of time and money on a 50 inch rider. I did some landscaping and reduced the "yard by about an acre. I let that acre go until early July, then mow with the 9 and bale it. After July I knock it down every 10 days with the 9 on a SH and it takes about 40 minuters to do the job. Believe you me, there's a whole lotta difference between 50 inches and 108 inches. Size DOES matter!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.