You have to love to one that went into effect in Feb say'n a licenced operator has to be on site at all times. State says I have to go half a mile down the road to get a raw sample. State says I can't leave the lab. Which one to you fallow? As for the Cl17's I ain't gonna fuss about drive'n around and checking them once a week and do'n that paper work, up till a year ago we had to drive around and get samples every day. We still have two sites with out Cl17s.
I have not read it, but my boss is say'n some time this fall we are going to have to start do'n NH3 test every shift with our other daily test, and the Hach method (which we use not when we need to) has not been approved by the state yet.
Reason I asked about the Green River is I was wandering if yall had the Synedra outbreak 3 years ago that far down? I am at the last plant on the Green. Most of the poultry houses for 3 complexes are up stream from me. We had nasty wet and warm winter, then a real hard freeze in Feb. Before the ground thawed it warmed up to 34 degrees and we had a 4" rain. For some reason no one wanted to say out loud we got slammed with NH3 and the river chemistry went nuts. When every thing settled down we had a Synedra out break that stopped our filters up. We had to slow down to 1/2 cappacity and still used more water back washing than we pumped out. Every plant I know of along the Green fought it for over a month.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
