Posted by Roger - Kansas on May 16, 2010 at 08:36:49 from (75.107.7.213):
Two years ago I bought a lot of items from an estate. I have been working on cleaning it up every since then. The end is in site and each weekend brings a new find and a story to go with it. After World War II anything new was tough to come by. Bill didn’t want to wait for a newer bigger tractor so he did the next best thing. He made one. He had this old Moline rear end that was in good condition but the motor was worn out. I’m not sure how he found it or made the connection, but he ended up with a Navy surplus motor out of a landing craft. Not sure if it was in a Higgins style boat or just exactly what. The motor is a six cylinder gasoline Hercules light weight (for the time) the base is a magnesium/aluminum material, cast iron blocks and flat head, dual ignition with two spark plugs in each cylinder. After a winter of making a frame, getting everything to match up and work right the big day came. Bill fired the tractor up and put it in reverse to back it out of the shop … but it went forwards. While trying to figure out what was wrong he noticed the cooling fan was running backwards. Not sure why but this motor runs backwards, so the tractor only had one gear forwards. It was driven out to the hedge row and parked where it set until several weeks ago. I was supposed to get this tractor, but Bills grandson decided he would like to have it and get it running. There are no hard feelings on my part and I sure hope he gets it running because I think this is a REAL conversation piece.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.