Posted by RoyIA on May 12, 2010 at 20:11:36 from (71.7.25.61):
I posted about the V-6 intake manifold gaskets a little while back. Last weekend I started the project. When I got the manifold off, they didn't look as bad as others that I had removed. It has 184K on it now and looks like it had the Felpro gaskets put in it sometime since it was new. I got it back together and first it would not idle. I took it for a drive and after a couple miles it was acting like the cruise control wouldn't disengage. The idle was way too high, around 2500. My son found the EGR gasket on the floor when I backed out. I replaced it and hoped that a vacuum leak was causing the high idle. Tonight I got back to it and it was idling about 2500 again. I disconnected the battery cable hoping it might clear some code. That did not help. Any ideas on where to start to get this under control. It ran fine until I tried to "fix it". Thanks in advance. P.S. I still do not know if I got the coolant leak fixed.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.