Tractor Talk Discussion Board |
Re: re-wiring ampmeter; 6V Pos to 12V neg groung.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Gman on June 06, 2001 at 19:57:59 from (32.100.18.39):
In Reply to: re-wiring ampmeter; 6V Pos to 12V neg groung. posted by Irv on June 06, 2001 at 16:41:53:
Ivan take the single wire from alternator to one side of ampmeter then off the other terminal go to switch key or batt. if it shows discharge reverse wires on ammeter that takes care of alternator.Now 6v.Positive to 12v neg.ground cable put on neg. post and hot cable put on + post,now go up to the distributor and coil and the wire going from coil to points put on _ terminal the + terminal will go up to the switch key and if you put electronic ignition in while you are doing this transformation you will be in bussiness. Hope this helps and don't confuse you to bad OLD JOHN T. usually handles thes ignition problems and upgrade he must be napping or something he's been awful quite lately. Later Gman
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|