Posted by Ken Macfarlane on May 06, 2010 at 17:37:06 from (216.198.139.38):
In Reply to: Re: old hay??? posted by 36 coupe on May 06, 2010 at 15:18:16:
Pulling the hay out of the stack is what saves it. Moisture moves extremely slowly in or out of a large stack but quite readily from individual bales. Moisture moves more readily out the cut ends. Once you"re more than 1 layer thick it doesn"t really matter.
A round bale is a good example, a fist size clump of wet hay in the middle generally can"t dry that out unless the rest is extremely dry.
I"ve never seen rock salt evaporate, has to get pretty darned hot for that, so it can"t spread through the bale like vapour.
Look at the acid application systems, they have to use a spray nozzle to evenly coat the hay going into the baler, it doesn"t spray the hay bales coming out the back end.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.