Posted by IA Leo on May 03, 2010 at 19:27:53 from (67.224.28.37):
I have seen more than once that Henry's Fordson was considered dangerous due to back flips caused by the worm gear final drive. Huh? So they put sheet metal fenders to enclose those wicked looking drive wheels and made the fenders stick out to the rear and enclosed the area for a much needed tool box. My knowledge of physics leads me to understand any method of driving the axle will cause a lifting motion on the tractor's front. Any method. Ever notice how short the Fordson is? I asked this question of a JD model D. It is equally as short. The answer I got was the radiator system took a fork lift to put it on, it was very heavy. I suspect the reason the Fordsons back flipped is due to the way the hitch was rigged and to not enough weight in front. The worm gear drive is historically inefficient, creating much more heat and sapping the final pulling power of the engine. How about stretching that amount of horsepower out like a Farmall H or a John Deere B and putting a heavy front post way to the very front. I don't see how worm gears cause rear-up. Leo
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.