Posted by JD Seller on April 24, 2010 at 21:49:41 from (208.126.196.117):
In Reply to: grinding PTO posted by JimS on April 24, 2010 at 19:28:15:
Your Ford 2110 has live pto or two stage clutch. This means that the pto clutch is controlled by the last few inches of the clutch pedal at the bottom of the stroke. If you push the pedal down real slow you should be able to feel the extra force needed to work the pto clutch. You need to hold the clutch pedal down all of the way for a few seconds before engaging the pto, Then release it slowly or you can damage the tractor or your attachment. If it is not operator error then your clutch might just need adjusted. You did not state how many hours where on your tractor, So it is hard to tell if your problem is wear related. This tractor was built for Ford by Shibaura in Japan. It is a simple tractor similar to Yanmar.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.