Posted by Chris in SK on April 14, 2010 at 07:34:55 from (72.37.171.116):
In Reply to: Re: muir-hill 101 posted by 4020deereboy on April 14, 2010 at 00:37:41:
I’d check all the easy stuff first….try it in position and draft, is the oil level good, filters? Try and get something heavy on it and work it if it’s been stuck up for a long time. Those rods that you mentioned from the rock shaft to the drawbar…..are you sure they are not part or the early type drawbar pickup hitch???? I’ve never see one here, but many UK tractors had a large hook draw bar…..early ones were raised and lowered by rods connected to the rock shaft arms. There was a latch type lever that you pulled, and you could drop the hook, back under a trailer/implement with a ring end, then pick it up (by operating the 3pt) without getting off the tractor. These used to rust up/jam up pretty good! The hook was interchangeable with a normal clevis end. It’s been a long time, so my description is probably a bit sketchy, but could it have one of these? The whole draw bar receiver under the axle would hinge down. (I don’t mean one of those little 8n type flat bars). If nothing else works then you’ve probably got to lift the top cover and check it out inside. Look on the Ford forum for info on this. Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
