Posted by Adirondack case guy on April 12, 2010 at 15:36:03 from (74.65.115.27):
I had to meet with a lady today, to access a site to determine how she could produce electricity. She had told me that she owned an abandoned Hydro Plant. After a 5mile drive down a dirt road I came to her place. She is an "off grider" I was quite excited to see the old power house, so down the trail on foot we went. We came to to a large stream and proceeded along a path until we came to a very large tyle block building. The building was abandoned in 1948. In the center of the building was around concrete silo like hole in the floor about 14' in diamiter, The 4' cast penstock pipe protruded through the back wall' and a set of rails were imbedded in the floor and ran out through where a large door had been.Presume a large lifting divice ran on these rails. the tail raceway dropped down the center of the runner wheel. and dumped back into the stream. My problem was there was no water flowing through the building.So I asked how the water got in to feed the turbine and she pointed to the disconected penstock. She said the penstock went up a steep bank about 150' to a point behind the original caretakers house, Her father went on to tell me that the water flowed 4.5 miles through a 6' diamiter wooden pipe connecting to a man made dam, built to supply the water.Mind boggling considering this power station was built in early 1900s and this aquaduct followed a man made path simular to a railroad bed.(see pic. with the wooden cradles setting on concrete footings). I did however find a spot up stream to install a modern day hydro unit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
