I don't think the steel crank would help much in any 6.2s or 6.5s made by GM. It is sometimes hard to tell what fails first, but it seems that most of the blown-up 6.5s with broken cranks go like this. The main-bearing webs in the block develop cracks. Overtime they get bigger and longer. Finally, a main-cap literally breaks off, leaves the crank unsupported, and the crank breaks into several pieces. I've got several such engines laying in my junkpile.
I've pulled the pan off many good running 6.2s and 6.5s with 200K miles plus on them - and ALL had cracks on the main webs. There is an aftermarket studp-girdle kit available - but I doubt it really helps.
With the very last 6.5s that GM built, they attempted to better the failure rate by making the outside bolts on the main-caps smaller. Went from 12 mm down to 10 mm. With the smaller outside bolts, more metal was left intact in the block.
The new 6.5 engines available with forged steel cranks have much heavier blocks. Also use a much higher nickel-content alloy.
Non-degergent oil and oil with no zinc and phosphorus additives is still needed in some older tractors. Especially with wet brakes that can get ruined with modern oil. If sold as "motor oil" is has to be rated as "pure mineral oil." Easier to get it in a can called "transmission oil." 90W GL-1 transmission oil is basically the same thing as 40W non-degergent, no-addtive motor oil.
Tractor Supply also sells standard non-degergent 30W and 40W motor oil. It has all the anti-wear additives but no degergent additives. I use it in old tractors if they are all sludged up inside and I don't want to know any of it loose. If I rebuild an engine, and clean it up inside - then I use modern degergent oil afterwards.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
