Posted by Don-Wi on April 03, 2010 at 21:01:48 from (75.232.135.113):
In Reply to: Moldboard plowing posted by casetractor5 on April 03, 2010 at 17:58:11:
I just plowed a larger field a week ago. I split the feild into several sections. I was between a feild that was plowed last fall toward the inside, and on the other side a feild that was sub soiled last fall. I started on the side that was plowed, threw into the furrow from last fall and made a split up the feild, plowed that all out. (ccw)
I didn't like where the dead furrow was gonna come out so I started on the other side in the middle of the field going around it CW. Once that side was done, I went to the otherside and went back to going CCW. In that 10 acre feild there are only 2 dead furrows, and there wasn't too much time on the headlands.
I have also split feilds into 3, did the 2 outside peices CW until I was at the edge of the feild and then in the middle went CCW. If I figure it right, that only leaves 1 dead furrow in the middle of a large feild, and 2 furrows on either outside edge of the feild that keeps the residential neighbors in check.
Maybe someday I'll find a 2 way plow and be able to flip it at the end of the feild and go back in the same furrow I came from, and have no dead furrows.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.