135 below is correct when he said that balloon had some oxygen in it also. I have been to oxygen acetylene safety classes put on by Smith. In that safety demo. the instructor will fill one baloon with pure oxygen and tie the end off. He would then fill another balloon with pure acetylene and tie the end off. Next he would light the torch and adjust to a netural flame. Next step is to snuff out the flame, then he would fill the third balloon with a 50-50 mixture of oxygen and acetylene. That balloon was tied off and put to one side, way off to one side. These balloons may have been 6 inches in diameter when inflated. He would then ask the class what would happen when he put a flame to each balloon. The pure oxygen balloon was first and it would go pop, the same as if someone had blown it up by blowing into it. The acetylene balloon would go boom. The 50-50 balloon he would ask that all the windows in the room be opened, (The room was on an outside wall) and everyone cover their ears. He would then place the balloon on his metal table, about four feet square. He would get under the table and wave his lit torch at the balloon until he hit it, that would result in a KA-BOOM.
He told us a story about being on the iron range putting on the same demo in a big auditorum for the mine workers. When he was filling the 50-50 balloon one of the people in authority did not think the balloon was big enough to be heard because the auditorium was so huge. He kept telling the safety instructor to make the balloon larger until the instructor refused to go any bigger. All the miners wore hard hats and wore ear protection, with the windows open the balloon was set off and most of the floursent lights in the overhead came tinkling down.
I was told the oxygen acetylene safety demo put on by Smith is now on video. Don't know if someone got hurt or if most class rooms don't have windows. It was 35 years ago I saw the demo and people today are more safety minded.
A friend from works neighbor filled a 30 gallon garbage bag with a 50-50 mixture. He set it off with a bottle rocket, that left a big crater in the ground.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
