Posted by Trkr on March 20, 2010 at 19:51:36 from (71.166.68.103):
In Reply to: belarus pto slips posted by boltcuter on March 20, 2010 at 13:52:53:
You have to take the pin out that hooks hyd.cyl. to the 3 pt.lift and shove the cyl. up out of the way.There you will see the cover that has the 5 bolts.Remove the cover and there are 2 band adjustment bolts that have a flat thin head on them.There is a slot on the bottom of the cover that these adjustment bolts nest in so they can't turn when the cover is in place.The pto control linkage has to be locked in neutral to make the adjustment.On the right side of the rear housing where the linkage comes down out of the cab,there is a bolt hole you have to thread a bolt thru the linkage into the housing and this will lock the pto in the neutral position so you can adjust the 2 flat head bolts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.