Tractor Talk Discussion Board |
Re: OFF TOPIC?? How to heat work shop, tractor barn and. . .
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul Stanley on April 30, 2001 at 12:39:53 from (142.22.16.53):
In Reply to: OFF TOPIC?? How to heat work shop, tractor barn and. . . posted by ShepFL on April 30, 2001 at 08:14:28:
I live in the Fraser Valley in British Coumiba, Canada. We have fairly mild winters, but no where as warm as Florida. I built a small shop, 500 square feet, and used radient floor heating. The walls are 2X6 with maximum insulation everywhere I could put it. The system runs off a 40 gallon water heater that supplies hot water to a laundry room and bath, also. If I was going to build a new shop, (and I plan on it), I am going to use geothermal with a radient heat system. Like the other post below lists, waste oil is cheap for now, but I can see it has too many negative aspects about it as well as wood fire.
Follow Ups:
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|