Posted by chevytaHOE5674 on March 11, 2010 at 18:15:48 from (97.95.90.129):
In Reply to: O/T CHAIN SAW BRANDS? posted by David from Kansas on March 11, 2010 at 16:37:19:
MarkB_MI said: (quoted from post at 18:40:01 03/11/10)The bar only needs to go halfway through the tree!
I cut trees for a living, and let me tell you sawing from both sides is time consuming, more work, and in some instances dangerous. Sometimes sawing from both sides is inevitable, but I avoid it whenever possible.
If your plans are to cut brush and 4" trees then a short bar will suffice. But if your going to cut 20+" trees I recommend a 24-25" bar.
That said I generally cut with a stihl 460 and 25" bar. But sometimes a Husky 372 or dolmar 7900 both with 25" bars.
This post was edited by chevytaHOE5674 at 18:22:20 03/11/10 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.