I have a close friend who owns an HVAC company... he specializes in radiant. I've spoken with him about this subject & according to him, you can install a radiant system with underslab foam insulation & the footing insulation, without the footing insulation, or with no insulation at all. In the latter case, he mentions that when you start up the heat for the season, it will take a while longer to warm the floor but, once warm, the ground under the floor will serve as additional thermal mass and will add to the overall effect. He said that the heat will go down about two feet or so, and that's it, so, no real problem and, as I mentioned, the soil under the slab just turns into several more tons of thermal mass. As far as heat loss around the perimeter, it's true, you will lose a bit there... might need some additional tubing to minimize "cold spots" in the floor near the perimeter walls. If you're worried that frost will be a problem that may affect your posts, one thing you could do is pour a slab completely around the perimeter of the building, width of slab will be equal to the depth of frost you experience in your location. Reason: soil under this slab will not freeze & the frost will move under the slab at an approximate 45 degree angle. So, if your frost line is 36", a 3' wide slab around the building will allow the frost to penatrate 36" deep by the time it gets to the actual building perimeter. This would also moderate the soil temperature at the perimeter of the building and further minimize heat loss at the edges of the slab. Keeps weeds & grass (fire hazard) away from the building as well! HTH ...D
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
