Tractor Talk Discussion Board |
Re: shimming f-20 rod bearings
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie on April 20, 2001 at 10:51:40 from (209.130.132.35):
In Reply to: shimming f-20 rod bearings posted by Shawn Erlandson on April 19, 2001 at 18:50:10:
I read through the responses below and I think you guys are missing where the shims are on a F-20. If its like my W30 the shims are actually spacers on the bolts that tighten the bearings. They are designed to have a few removed as the bearings wear. When I did my W30 I did it by trial and error. I put some on each pistion and turned over the motor and messed with them until it seemed too tight, then added a couple. Obviously I'm not an expert mechanic or I would have had a better way to do it. If the F-20 is different or I misread what everyone is saying then just ignor me - I'll probably be wrong again tomorrow.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|