Posted by 135 Fan on March 01, 2010 at 21:11:31 from (68.149.56.30):
In Reply to: Thomas 133 skid steer posted by BradinPA on March 01, 2010 at 16:42:39:
The sprocket on the axle? I had a guy take my axle out to put a speedy sleeve on it for me in his shop. The drive motor didn't have to come out. The book shows some special tools, an axle installation tool, a seal installation tool and an axle remover. Got it done with out any of them. Axle remover is just a slide hammer set up that bolts onto the hub. The axle has a nut with a cotter pin through it and the sprocket has keys(3 I think) to hold it on. I think he might have split the chain to get the axle out. Sorry I can't be more help. It was done about 11 years ago but the drive motor didn't have to come out. The book might even say the drive motor has to come out but I know mine never came out. Mine was on the left side though and the motor is more towards the front. I've had to fix the chain adjuster and the book says to take the motor out as well but I just took the E brake disc off for more room. Not much room to get at the chain adjuster on the left side. I've found that if you hear a clicking sound, especially when backing up, you have a loose drive chain and it's hitting the chain case. The 3 5/8" grade 12 bolts for the chain adjuster will break if you try to do any hard digging with a loose chain. I think the fact that a piece of key stock is welded to them makes them break easier. BTDT I made my own bolt assembly using only grade 8 bolts so they might have a little give before snapping off. I think after the chains stretch a few times and are adjusted, they stay pretty good. I haven't had to adjust mine in a long time. Don't tighten them too tight though. Dave
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
