Tractor Talk Discussion Board |
Re: Painting Tractor - Problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by D Smoker on April 17, 2001 at 16:02:32 from (64.41.22.163):
In Reply to: Painting Tractor - Problem posted by Troy on April 17, 2001 at 15:35:41:
I wet down the floor before I paint. Just lightly to keep the dust down. I think no matter how careful you are, you will pick up the dust in the air and push it onto the metal while painting unless you have a paint booth, and if you look carefully at some of the new cars you can still find airborne dust in the paint, so even that isn't a cure -all. The only way to completely eliminate the dust that gets in the paint is to use a fine sand paper after painting and follow with progressively finer compounds and polishes, simply a lot of hand work after the painting. If anyone has an easier solution, I'd like to hear it also because I have the same problem and all that rubbing and polishing can be alot of work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|