Posted by Don-Wi on February 26, 2010 at 19:13:19 from (75.205.21.63):
In Reply to: Welding VS Machining posted by Lanse on February 26, 2010 at 18:44:43:
I'm a machinist by trade, but I can also weld, and do it well. Being a welder all day, everyday, doesn't appeal to me. It's fairly dirty, it messes with your eyes, and it's miserabel in the summer heat if you're not working in a climate controlled shop.
As a machinist, just don't let those tight dimensions intimidate you. When the tolerances shrink, we go to a more accurate way of doing things. You don't use a drill to hold a .001 tolerance, and you don't use a boring bar to hold .020. For every job there is a way.
Machining is (normally) cleaner, and not as hard on a guy's body. If you become good at it, you can command a pretty healthy wage too, you just need to be patient.
I got into machining in High School, and have been employed in the field now for almost 8 years.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.