Posted by dave2 on February 24, 2010 at 03:51:53 from (91.10.173.176):
Don't beat me up folks, just set me straight..... You don't see a lot of cattle on pasture here in my area unless they have their bellies full and have a little space to enjoy the sun. Just got offered a couple bull calves for next to nothing and have access to hay, silo hay, corn silage, and corn within a half mile. Horses will be vacating the stalls in a couple weeks until about November. Trying to find the breed, but these are dairy cattle but big hefty ones not like jerseys or holsteins. Could I take a couple calves and have them ready to butcher/sell by say October?
Don't care that muck for the beef here, but if I fed it like you folks do, I'd have some good stuff I think.
If I can have them gone by October, I could do 3 or 4 and maybe pay for feed/pasture rent for all including horses. At least, I'd be shoveling sh!t for something that was paying for itself.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
