Posted by ldeikis on February 22, 2010 at 08:51:04 from (74.38.159.27):
Hey guys. You all got me through redoing the brakes on our other G last summer, hopefully there's some help available here. We've got a G with the OEM rear furrowing bar cylinder and bracketing, rigged to lift a homemade bar. This whole rig was built early last summer, which was when the farm got the tractor. The "furrowing" bar is basically a piece of square stock with a couple brackets for sweeps welded on, so the thing can clean up the wheel tracks while it cultivates the bed.
All summer this worked fine--you had to give it some throttle to get it to lift the bar, but it could do it every time. But the cylinder was leaking, just a bit, but enough to make a mess of the ram and I was worried about abrasion and it getting worse. So I ordered the packing material and pulled it all apart, tapped out the old packing, pressed in the new in the same order, and reassembled it all.
It doesn't leak now, but it can't lift the furrowing bar! It tries--you can see it heave--but it doesn't have enough ooomph to do it. Any ideas?
I'm wondering about an air bubble trapped in the lines or cylinder? After hooking the hydraulics back on but before mounting the assembly, I manually compressed the cylinder and, holding it below the level of the tractor, ran it through several extend/retract cycles hoping to burp it. Not sure if that's enough with a 1 way cylinder though. Does it need to be bench bled or something? The tractor's full of fresh hytran as of November or so, and I know the level's good.
Thanks for any pointers--I'm going off to work for another farm this season and I'd really like to leave this little guy in good health.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.