It has become obvious that I'm not the only person that has moisture collecting inside their hyd system. I think there are 2 reasons that old tractors have this problem. #1. The oil temps don't get warm enough. My backhoe has no problems with moisture. When I run it, you can touch the hyd cylinders and notice how hot they get. #2. No air vent on the Jubilee. My backhoe has an air vent on top. I want to find a material that will absorb the moisture inside the hyd and transfer it to the outside to dry. Scientists call this process capillary action. I also want to use the existing fill plug hole to do this. Once I find the best material that will absorb and transfer moisture, I'll put an umbrella over it to keep the rain off it. This vent must also be able to keep the dust and dirt out. The last thing I want to do is put an additive in the oil to suspend the water in the oil. Perhaps I should have better defined the problem and my goals. Other people think the solution is to change the oil. My oil is only 6 mo old, so the oil is not the problem. Condensation is my problem and making a vent is the only solution.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
