There was a Ford snowplow blade made for N's,and it would prolly fit a Jub(600series).However as mentioned below,it was cable/pulley lifted by 3pt arms,thus negating 3pt blade use while installed...however in my opinion...it would be relativly simple to build a snow(NOT dozer)blade for a Ford. -Heavy Plate-angle iron type brackets under rear axle on fender bolts.(single pivot front axle not designed for pushing) -Two 1/4x2x3 sq tube arms from brackets to ahead of tractor,cross braced near frt,rear& cntr to clear clutch/pan when raised. -Pickup truck blade(w/o lift mech)adapted -Front Ford type bumper -lift could be hydraulic or winch mounted to bumper. -crossed chains from push frame to frt axle to limit wandering Just my musings..I'll have a Ford again someday.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
