Posted by Mark - IN. on February 02, 2010 at 16:14:49 from (64.12.116.74):
In Reply to: O/T Metal Casting posted by Christos on February 02, 2010 at 14:52:44:
I don't know of any sites, but I sure do wish you luck. Never know how these things might turn out if you get good at the craft. I knew a couple of brothers that had their own small foundry that grew over the years, nothing to stand the world on end, but grew over the years and kept their bills paid and them and their families fed and clothed. Took up a lot of their time, but they loved it. Gotta kind of be an artist to cause someone's gotta make them molds, and that's going to be you. You're going to be attending auctions too to pickup good used stuff like ovens, coolers, maybe forges, and a whole lot of stuff no different than an independent machine shop that builds over the years and hopefully generations. I've got friends, three generations in a machine shop they've built over the years, father, 5 sons, and now a couple of grandsons, and not to forget a couple of daughters and daughter-in-laws in the office. I don't know if you'll ever get rich, but when your day job starts getting in the way of making better money in your side job (foundry), then you'll have crossed the threshold into self employment, make it or break it of your own desire and free will. That'll be a great place for you to be too, if you're honest and good at what you do.
Much good luck, the best, and it has to start somewhere...from within.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
