Posted by bc on February 01, 2010 at 22:44:29 from (71.158.221.179):
In Reply to: O/T Trailer sway bars posted by 37 chief on January 31, 2010 at 20:26:35:
Stan, I'm not sure anyone answered your question on how to use them. I used one with my 22' travel trailer behind my 93 ford exploder 6 banger. The two bars and chains are for the load leveling equilizer hitch and the anti-sway bar is to stop the sway. Two different functions.
Jack the trailer down on the ball on the equilizer hitch and tighten up the ball. Jack it back up so the ball and rear end of the vehicle come up a little. Hook up the two bars, one on each side, and hook the chains up (onto the brackets mounted on the trailer) as tight as you can get them. When you jack the trailer back down till you pulled the jack up to its limit for traveling, the weight of the trailer and hitch will be on the bars and chains. If you don't think the bars are taking enough weight or if you are close to getting another chain link to hook, then just jack the rear end up a little higher (after the hitch ball is engaged of course).
The little ball is for a flat bar style "anti-sway bar". One end fits over the ball and the other end hooks onto the side of the trailer tongue where the bracket for it is. Then tighten up the tightening screw lever on the anti-sway bar. They can be a life saver when a big travel trailer starts getting wind whipped around or when you are passed by a semi on a windy day.
The equalizer hitch should have adjustment holes so that the trailer is level when all hooked up.
I pulled that trailer all over the mountains and up to Jellystone Nat. Park with that kind of hitch and couldn't have done it without it.
Seems like the hitch and bars weight a hundred pounds by themselves.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.