Posted by Jake in NY on January 30, 2010 at 08:43:58 from (24.2.247.11):
In Reply to: Grazing- Who does it? posted by Don-Wi on January 29, 2010 at 19:44:29:
I had a small grazing dairy for 5 years until I got out last March.
Definitely go to the grazing conference. I think I know which one you are talking about and it is definitely worth it. Also, definitely check out graze.com and if you get serious about grazing then absolutely get a subscription as it is worth its weight in gold. McNair is the only person around who focuses on US style dairy grazing.
Grazing can definitely save you money and increase your net profits. But it is not an overnight solution and it will require a good bit of management. But, the same can be said of growing any other high quality crop. If you grow corn, do you just throw it in the ground in the spring and then forget about it til fall? Not if you want to make money! Treat your pasture just like any other crop and focus on the most efficient way of turning that grass into milk.
There are some "consultants" in the grazing field that are useless and a waste of money. If you to the conference try to meet other dairy farmers who can give you "real world" advice. And most of them will tell you to avoid "consultants" like the plague.
Personally, I would never even consider farming without intensive grazing. It is such a labor saver, and gives you a lot of tools for increasing profitability. Remember, unless you are going to start bottling your own milk, your best chance for profits is in cost control and grazing can do that very well.
Be wary of graziers that are very low/no grain feeders. They are doing something that can take years to learn to do correctly and I still feel they are leaving profits behind. You can feed less grain during the summer months than the winter but I would not want to go below 10-12 lbs or so.
Feel free to email me if you want more info or have other questions as I have always loved to talk grazing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
