Posted by trucker40 on January 29, 2010 at 09:53:13 from (69.149.165.244):
In Reply to: Cracked loader arm posted by Doug - Iowa on January 28, 2010 at 18:42:39:
MIG is the right way to fix it.Cut or grind or somehow get all of the old weld off,V it out and weld it uphill with MIG if possible.Then I would grind the weld down flush and put a plate over it.If you do put a plate on it you want to keep your weld an inch from the top and bottom of square tubing and weld it longways as much as possible.So if you weld right up to the top of the square tubing and all the way across the face of it,it will probably crack right beside that weld.So if you can taper the ends so you dont have a long weld across the face of the tubing.You dont want to weld across the corner or even get closer than an inch from the corner of square tubing.If its cracked there when you start v it out and weld it then grind flush which is about as good as you can get it,but if it cracked before maybe it will again. There is nothing at all wrong with using a MIG for that.Its probably the best way to do it and will probably take more abuse than stick welding it.It will probably break somewhere else before it breaks there again if you use a MIG.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.