Posted by KYfarm on January 29, 2010 at 05:11:06 from (74.128.24.86):
In Reply to: Re: Welding question posted by 135 Fan on January 29, 2010 at 01:21:02:
Not sure you are correct about the structural shops 135fan. I owned a structural steel fabrication shop and have visited dozens of others, also I have read the spec book and bid on thousands of jobs, not one spec book I read said anything about mig welds not being qualified. All of them said 70 series wire or electrodes were needed. As said below, ER-70.... wire is qualified.
All our welders had up-to-date certificates and all welded "tickets" to be tested by local certification house. All the "tickets" were 1/2" plates, v'grooved with a 1/8" gap and welded up-hill, as necessary to be certified in all positions. Root pass is done with hard-wire and all other stringer passes done with 70 series flux-wire (outershield) WITH gas, 75/25.
Also, if a drawing called for full-penetration or large size fillet welds this was always done with with wire machines and 75/25 gas on multiple passes. Sometimes dozens of passes on one full-penetration weld.
The only reason we had a stick machine was if we had to weld a bunch of galvanized material we set up outside so the smoke wouldn't make everybody sick.
We use hard wire .035 (no flux) and gas on misc. steel, like stairs and handrail and light work and fluxwire .045 (outershield) and gas on heavy structural. Never had a weld fail.
That is just my experience here around the Louisville, KY area.
On the farm I have a gas engine Miller stick machine and I use 7018 rods for everything I make sure to clean everything as well as possible. Just not feasible to keep a wire feed welder on my farm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.