Tractor Talk Discussion Board |
Re: Re: Question about checking hydraulic pressure
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(Mo) on March 20, 2001 at 08:09:23 from (164.214.4.51):
In Reply to: Re: Question about checking hydraulic pressure posted by Greg D. on March 19, 2001 at 18:31:09:
The center plate in the original pump cracked. The consensus was that water froze and cracked it (it did happen during the coldest days of this winter)or that the pressure was too high. At first I thought maybe the water freezing did it. Now I wonder if I don't have an excessive pressure problem. That is why I want to get an accurate check on the pressure. The relief valve is adjustable. shims behind the spring to increase pressure and crush washers at the valve stem head to reduce pressure. I have no shims in and have inserted a crush washer. By all rights I should be below normal pressure, yet my reading was WAY HIGH! I'll break it down again next week-end to check the valve & seat again, and try again. Thanks Stan(Mo)
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|