Posted by eastexan on January 18, 2010 at 16:57:24 from (96.15.9.51):
In Reply to: Anvils posted by barn E on January 18, 2010 at 08:02:06:
paul said: (quoted from post at 11:20:25 01/18/10) Anvil is kinda specialized material, can't easily cut a piece off, then weld it back on, and have it work. Every angle & point and hole is for a use. I don't think you'd have a 'good' anvil welding it back together. Beating on metal isn't a place for kids, so I'm not sure I understand why someone would cut up a good anvil & make a piece of scrap metal out of it for 'safety', but I wasn't there....
--->Paul
Actually, it was just the sharp tip that was cut off when I got it. So all I have to do is build it out an inch or two with 7018 rod and then bevel it out with an angle grinder. That would be good enough for my use.
It's a kid's nature to play and chase each other around things, so I can see why someone with kids or grandkids might want to cut the sharp tip off an anvil. I wouldn't go to that extreme. I might put a can or something over the tip when I wasn't using it, if I was worried about it.
When my daughter was little, she ran into the edge of a table saw and almost put her eye out, so I guess that's why I'm a little more cautious than others might be. You can tell kids not to play around certain things, but that don't mean they will always listen.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.