Posted by KEH on January 17, 2010 at 15:52:54 from (67.231.175.170):
In Reply to: What have I got here? posted by Bill from Scotland on January 17, 2010 at 12:43:34:
I don't remember you posting about having any MF tractors that would be a load for that 3 axle trailer, but it needs a lot of modification to make it a tractor hauler. Can't see everything from pics, but looks like you have 2 opeions. 1. Floor down inside the frame rails and cut out the rear cross member to the level of the new floor. Best option if the tractor will fit between the side railes. 2. Floor flat across the side rails, building up crossmembers to go under the new floor. It would then be wide enough for anything reasonable but you would have to have long ramps to load that high. I get nervous loading a tractor on my gooseneck, but then I'm the nervous type when loading tractors.
That SUV in the pics looks a little light to be pulling a heavy trailer with much of a tractor, but I understand the German licensing/tax laws allow some light combinations.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
