Tractor Talk Discussion Board |
Re: need to make tapered hole..how is it done
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob LaBrie on March 05, 2001 at 10:21:10 from (32.101.170.152):
In Reply to: need to make tapered hole..how is it done posted by Bob Labrie on March 03, 2001 at 12:38:24:
I decided to use the original boss with the tapered hole made at the M-H factory. Thanks for the advice. Look at my idea to retrofit the old piece of broken cast iron. I'm building my own bracket. I don't like to spend money at a machine shop unless it is absolutely necessary. I'll be spending plenty when I fix the old continental flat head soon. Thanks again. Look at photos 22 and 23 communities.msn.com/locorebob/PhotoAlbum Much appreciated Bob LaBrie
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|