Posted by trucker40 on January 06, 2010 at 09:25:10 from (70.240.144.163):
In Reply to: Re: Broken dowel pin posted by TimV on January 06, 2010 at 08:25:03:
I have drilled them before with no problem.Im not saying his wont be a problem,just that I have done it with no problem.Maybe they are only hard on the outside if he is lucky and the inside is soft.
Im not saying that you cant weld something like that.If I did somebody would weld it just to show me I was wrong.However something that small is usually hard to get a good weld on it.If you cant drill it then thats whats left but its better to tap it if you can.Unless you are real careful with sparks flying everywhere up on top of a motor you could have a fire,you could weld everywhere except where you need to and you could mess something else up,you could have spatter stuck to a cam lobe or crank journal or something.You could cause more damage.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.