Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Pertronix problem?


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by TimWafer on January 04, 2010 at 14:23:33 from (173.85.181.132):

I installed a Pertronix ignition on my Skid Steer about a month or more ago. I used their flamethrower 3-ohm coil and all seemed fine at the time. In fact it was running great back when it was warm! Haven’t really used it since then. It just has a little Wisconsin V4HD engine in it by the way.
Yesterday I need it because my diesel tractor gelled up and we got about a foot of snow and I needed the skid steer as a backup to dig out.
It started initially but was pretty sluggish which I attributed to the cold. Usually it warms up in a few minutes and is fine but it seemed to get worse and eventually seemed like only 2 cylinders were firing. I limped it back to the barn and found that pulling the plug wires off either or both of two of the cylinders had little effect while doing the same on the other two made it die or nearly die. Also noticed that the spark would jump at least a half-inch on the two good cylinders while barely noticeable on the two weak cylinders. The plugs are new and I set them to .035” I replaced the cap & rotor today since I saw some moisture underneath. None of that helped the situation however and I’m getting frustrated. I guess I can replace the wires next unless somebody has another idea what the problem might be. Couldn’t really see any sparks leaking from the wires in the dark but doesn’t mean there isn’t.
I finally got the tractor started after replacing the filters and bleeding the whole system so I’m not desperate at the moment but it is still snowing.
Tim



Replies:




Add a Reply

:
:
:

:

:

:

:

:

:

Advanced Posting Options

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.



 
Advanced Posting Tools
  Upload Photo  Select Gallery Photo  Attach Serial # List 
Return to Post 

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming. ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy