Tractor Talk Discussion Board |
Re: 1952 ford 8n front end spindle bushing radius rod pin
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve W on February 19, 2001 at 08:01:12 from (24.169.113.150):
In Reply to: 1952 ford 8n front end spindle bushing radius rod pin posted by m.kennamer on February 18, 2001 at 09:31:35:
My 2N didn't have any grooves, and though they were well worn, they had never been replaced in 59 years of hard use. If you decide to keep the aftermarket ones, keep in mind they are sized just a little small, to compensate for a little spindle wear. I replaced my spindles, because the design of the spindle arm was later improved. To enlarge the ID of the spindle bushing, use one of those cheap (5 dollar) master cylinder brake hones in an electric drill. Took me about 5 minutes a side to get a nice fit. Hit em with a greas gun once in a while, and you should be good for another 60. Take Care Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|