Tractor Talk Discussion Board |
10 ft bladed pull behind grader:anyone know something about them?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by solates on February 18, 2001 at 05:21:37 from (172.130.180.142):
over 5 years ago my father traded a working old tractor and a few junk iron pieces to my cousin in law for an antique road grader. it is a standup version(guessing since the only place the operator could have been is on the metal grating located at the rear) has metal wheels to turn the blade and adjust for height. all the gearboxes and wheels are in good condition(they even still work), the body is in good condition. blade still in tact. all in all a testament to the way they built things back then. anyways he was curious so had it appraised, appraiser actually said it was a pre-eight foot blade version, one of the first type made. incidently it has no enginge just an offset hitch with hole about 10 foot long sticking out the front of it. any further info would be much appreciated, if possible. thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|