Tractor Talk Discussion Board |
Re: new pics of my M-H Pacer...need help to id features
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F14 on February 15, 2001 at 05:43:32 from (216.252.28.171):
In Reply to: new pics of my M-H Pacer...need help to id features posted by Bob LaBrie on February 15, 2001 at 04:32:47:
I'm not a Massey Harris guy, but I can answer a couple of your questions. The head probably CAN be rebuilt if it's not too badly warped, but it will seriously expensive, needing valve guides, new seats, new valves, and milling. I'd start looking for a new or rebuilt one. The hole in the bottom of the flywheel housing is usually to allow dirt, debris and oil from the rear main seal to leak out. Rear main seals frequently leak, even when new. You COULD use it as a point to support the tractor when split, but that's not what it was put there for. The brackets on the lower hubs and on the brake housing were/are mounting points for various types of implements. The knob on the lower right of the instrument panel is most likely and on/off type ignition switch. Choice B would be a choke lever.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|