Posted by ben brown on December 14, 2009 at 04:45:08 from (12.213.80.36):
In Reply to: F2 GLEANER posted by DAL on December 13, 2009 at 18:03:41:
that engine ues a roshmaster pump. take of side plate held on by two screws from both pumps the new one is probly in time all ready trun engine over intell the markes to lines line up on pump on engine. you well need to remove injuction lines and any other thing in the way of pulling the pump off drive shaft. if you look down in the new pump you wll see a mark that is to one side of where the pump drive shaft ingages there is also a mark on the drive shaft thoes two mark line up also if you cant find the marks on the old pump looking through the side window. the drive shaft well only fit one way, you should replace the two unbrella seals on drive shaft you should have got new ones with the pump. thy can be a pain gettng first one in make sure you dont roll it back putting on new pump. what ever you do dont take of the front plate and remove the gear or you well get it out of time and then you well have fun retiming.
This post was edited by ben brown at 04:46:41 12/14/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.