The problem turned out to be the wrong pressure plate. When I took the old pressure in to be rebuilt, the shop was not able to rebuild my old unit so they ordered a rebuilt from another shop. When it came in a week later of course my old pressure plate was already in a pile somewhere else so no side-by-side comparison was done.
This model tractor uses two different transmissions, a hi-lo-reverse and a constant mesh transmission which is what I have. The constant mesh transmission has an extra shaft which is run off the pressure plate with a set of splines. The pressure plate I got is smooth inside and fit just over the splines on the shaft. That is why I was getting a grinding noise and why the pump wasn't working. Actually it probably was turning just a little which explains a dribble of oil thru the lines.
So now I have the pleasure of breaking the tractor apart again and installing the right part. Thanks to each of you for your replies and interest.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.