Tractor Talk Discussion Board |
Re: Any one ever Built a Home made rock picker???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by T_Bone on February 06, 2001 at 13:41:46 from (207.254.53.111):
In Reply to: Any one ever Built a Home made rock picker??? posted by Canadian Cowboy on February 05, 2001 at 15:51:43:
Hi CC, I made a leveler out of RR rails that picks rocks pretty well. The rail irons weigh about 900lbs a piece 10ft wide and I have two with 2" pipe 10ft inbetween the two rails with a 1/4" x 2" flat bar in a X shape to keep it square. If chain link was added to the rear rail then it would trap the rocks more but we have pee gravel here so thats not a concern with me. After one pass on the ground the front rail digs in about 6" and the back rail floates in dry ground. In wet ground it would not be possible to pull this drag with out a large tractor. I use a 4wd pick-up to pull it and will pull well with my IH 340U with a backhoe. I had the pick-up before I bought the tractor! This design would be ok for rock picking if you have a front loader to lift the rear rail to dump the rocks. 90lb RR irons cost $10 a 10ft length used plus a cut charge if you don't have your own torch. I would not put more than 12" high chain link on the back rail as I don't think a average tractor will pull it full of rocks. T_Bone
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|