TominKy said: (quoted from post at 20:40:22 12/07/09) Old: I had a 1980 suburban with 4-wheel drive that could not be driven on dry pavement, so obviously the gear ratios were different fore and aft and allowed for some slip on slick surfaces. That being said I have no idea what the ratios were front to back, but from that experience, I would say that if driven in four wheel only on slick surfaces the close ratios will be fine.
Tom
Tom you can't do this on many 4x4's. There's enough wear on tires, or even difference between tires, that you cannot and should not run conventional 4x4's on dry pavement.
My old Toy Landcruiser had identical front/ rear--4:11
Many US 4x's have slightly mismatched ratios. For example, nearly all (especially older) 4x4's used Spicer front axles and not necessarily Spicer rear. This meant that your Spicer 3:54 or 4:10 front might not match your "Corporate" 3:55 or 4:11 rear, thus you were "off" right out of the chute.
Except for "full time" 4x4's no conventional transfer case was ever meant to run on pavement, wet or dry.
I've never heard of some of the ratios being discussed here. I would suggest you recount the teeth. By the way it's REALLY inconvienent to refer to an axle by tooth count, since no one else does.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.