Posted by LOU from Wi on December 03, 2009 at 01:00:48 from (174.124.84.159):
In Reply to: Autolite sparkplugs posted by dave2 on December 02, 2009 at 23:57:21:
Hey Dave. Some time back I said on this forum to take a Volt Ohm Meter (Set on Continuity)place one probe on the top of plug-other probe on the contact comming through the plug NOT THE BENT GROUND but the stem. You will find a considerable drop in readings, Some more then others. I have always went through this proceedure when getting new plugs. Always put the less resistance plugs to the farthest plugs in the engine. Weakest readings ones to center of the engine,Results are great. Found even new plugs dead from the box.(No readings on meter) Took em back to supplier and showed them the difference. First they didn"t believe me but when they went back and pulled another new plug from the shelf then the point was proven. I also would look inside the distributor ,bet you will find rotor button coroded and also the contact points in the distributor as well. Those can be cleaned(lightly sanded with crocus cloth. We also bought a sparkplug sand cleaner (air driven) from J.C Whitney. Use it in conjunction with the meter as time goes on with the usage of the vehicles so we can get more usage from the plugs. Works for us. 6 trucks 2 tractors several lawn mowers & 1 Yard vac.(no partrige in a pear tree) lol. Almost forgot the O.C.46 crawler comming in soon. Just a good suggestion from LOU
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.