Posted by jdemaris on December 01, 2009 at 15:24:01 from (67.142.130.48):
In Reply to: Re: Chain Saws posted by Todd Hovick on December 01, 2009 at 14:47:25:
I don't know what part of NY you're in. I cut in central NY (Otsego County) and further north on the Tug Hill Plateau (Jefferson Co.). I get a fair amount of hard maple that's 4 to 5' diameter near the bottom, along with old twin-trunks that are siamesed and even wider. For them a 20" bar and chain won't do the job. Close, but not close enough. Granted, probably 95% of what I cut can be done with a 20" bar or even 16", but I don't like to leave the other 5% behind to rot. These past few years, the power companies have been cutting down old growth hard maples all over the place, so I've been cutting a lot of huge wood that few other people want to mess with.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.