Posted by MF Poor on December 01, 2009 at 02:57:37 from (72.4.0.230):
In Reply to: Subsoiling (ripping) posted by 37 chief on November 30, 2009 at 18:31:16:
Discing is counter productive for reducing compaction. It actually CAUSES the problems you're trying to eliminate. A combination of the tractors weight and the compaction from the disc itself creates a compaction layer that will hold water. Deep ripping or subsoiling will do far more to eliminate that compaction layer than most any other tillage method.
The BEST results with ripping are achieved when the ground is dry. You'll get more shattering action as opposed to merely ripping a slit in the ground.
Ground will eventually "heal" itself from compaction with freeze/thaw cycles, and the "heaving" that causes. That's one of the underlying principals in no-till farming. That however, takes time.
Not claiming to be an expert in the subject, but I've had good results with subsoiling in a couple wet fields of mine. I did it with a single shank subsoiler, and was moving overe each pass just slightly more that half the tractors width. (Running tractor wheel just clear of previous pass) It worked for me, YMMV.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.